How to measure: Bespoke Bedspread

How far the bedspread falls is a matter of personal preference. Many prefer a bed throw that reaches down towards the floor for an elegant and inviting look, while others prefer it to end slightly above the floor for a more relaxed look. The measuring guide below assumes that the bed is freestanding in the room and is intended to provide a bed throw that reaches down towards the floor on all sides.

To achieve the right drape, you need to measure the width, length and height of your bed.

1. Measure the width of your bed

Measure the width of your bed from side to side. Then calculate:

Bed width + (2 × bed height) + 10 cm

The additional measurement allows the bedspread to reach down to the floor on both sides while also allowing room for a fluffy duvet.

2. Measure the length of your bed

Measure the length of your bed from the headboard to the foot of the bed. Then calculate:

Bed length + (1.5 × bed height) + 10 cm

This provides enough fabric for the bedspread to reach the floor at the foot of the bed, while leaving extra fabric at the head of the bed to accommodate pillows. The additional 10 cm also allows for a thicker duvet.

Example:

If your bed is 160 × 200 cm and 50 cm high:

Width: 160 + (2 × 50) + 10 = 270 cm

Length: 200 + (1.5 × 50) + 10 = 285 cm

You would therefore need a bedspread measuring approximately 270 × 285 cm.

-

If your bed is against a wall: If one or more sides of your bed are against a wall, the bedspread does not need to reach the floor on that side. You can adjust the measurements according to how you want the bedspread to drape.

Please note: Maximum width varies by collection. Woven Linen and Cottage Collection bedspreads can be made up to 310 cm wide, while Bouclé and Sakura Collection has a maximum width of 290 cm. The maximum length is 350 cm for all collections.

Good to know: Beds come in a variety of heights. As a general guideline, a total bed height of around 50–70 cm is common for adult beds, but always measure your own bed for the best result.

Tip: Measure from the floor to the top of the mattress, including the mattress topper and anything else that would normally sit underneath the bedspread. This is the actual height of the made-up bed and the measurement you should use in the calculation.