How to measure: Bespoke Bed Throw
How far the bed throw falls is a matter of personal preference. Many prefer a bed throw that reaches down towards the floor for an elegant and inviting look, while others prefer it to end slightly above the floor for a more relaxed look. The measuring guide below assumes that the bed is freestanding in the room and is intended to provide a bed throw that reaches down towards the floor on all sides.
To achieve the right drape, you need to measure the width, length, and height of your bed.
1. Measure the width of your bed
Measure the width of your bed from side to side. Then calculate:
Bed width + (2 Ă— bed height) + 4 in (10 cm)
The additional measurement allows the bedspread to reach the floor on both sides while also allowing room for a fluffy duvet.
2. Measure the length of your bed
Measure the length of your bed from the head of the bed to the foot. Then calculate:
Bed length + (1.5 Ă— bed height) + 4 in (10 cm)
This provides enough fabric for the bedspread to reach the floor at the foot of the bed, while leaving extra fabric at the head of the bed to accommodate pillows. The additional 4 in (10 cm) also allows for a thicker duvet.
Example – US Queen Size Bed:
If your bed is 60 Ă— 80 in (152 Ă— 203 cm) and 20 in (50 cm) high:
Width: 60 + (2 Ă— 20) + 4 = 104 in
Length: 80 + (1.5 Ă— 20) + 4 = 114 in
You would therefore need a bedspread measuring approximately 104 Ă— 114 in (264 Ă— 290 cm).
-
If your bed is against a wall: If one or more sides of your bed are against a wall, the bedspread does not need to reach the floor on that side. You can adjust the measurements according to how you want the bedspread to drape.
Please note: Our bedspreads are made to a maximum width of 110 in (280 cm) and a maximum length of 138 in (350 cm). If your calculated measurements exceed these dimensions, please contact us before ordering.
Good to know: Beds come in a variety of heights. As a general guideline, a total bed height of around 20–28 in (50–70 cm) is common for adult beds, but always measure your own bed for the best result.
Tip: Measure from the floor to the top of the mattress, including the mattress topper and anything else that would normally sit underneath the bedspread. This is the actual height of the made-up bed and the measurement you should use in the calculation.